Will you be able to do any fab work before leaving? Also what kind of help do you have for setup and teardown?
I have a design for modular wooden platforms that typically are built out of 3/4" plywood and 2x4s. usually setup on 4x4 or round pole type uprights.. But they require some time on the shop to fabricate each unit (best size tends to be 2' by 2' squares.)
The problem with working with full 4x8 sheets as the size factor for each panel is that a.) they will warp, b.) heavier cross-bracing is required to prevent the floor from swaying and "drumming" and c.) regardless of bracing they will warp...
I would think in terms of at least cutting them into 4' by 4' panels.
(no subject)
I have a design for modular wooden platforms that typically are built out of 3/4" plywood and 2x4s. usually setup on 4x4 or round pole type uprights..
But they require some time on the shop to fabricate each unit (best size tends to be 2' by 2' squares.)
The problem with working with full 4x8 sheets as the size factor for each panel is that a.) they will warp, b.) heavier cross-bracing is required to prevent the floor from swaying and "drumming" and c.) regardless of bracing they will warp...
I would think in terms of at least cutting them into 4' by 4' panels.
Janice